Magnalube-G Technical Spec Sheet

Technical Specification Sheet
Magnalube-G is a non-soap elastomer/PTFE lubricating grease formulated with the highest quality raw materials. Magnalube-G has a unique formula that molecularly binds PTFE with polyurea for superior performance in a wide range of applications. The grease will prevent breakdowns, and extend operating intervals in most cases. It is fortified with a number of proprietary additives that inhibit rust and oxidation as well as giving added resistance to extreme pressure. Magnalube-G has a dropping point of well over 500°F. It performs well in harsh environments, especially when users want to avoid migration and water washout. This is a superb all-purpose grease, and is often found to solve problems that other greases cannot.
NLGI Grade 2
Thickener Type Polyurea/PTFE
Additives rust inhibitors, oxidation inhibitors, extreme pressure, PTFE
Texture Smooth
Color Blue Green
Food Contact Rating NSF Rating H2
Worked Penetration, 60 Strokes, ASTM D 217 287
Roll Stability, % Change, ASTM D 1831 Less than 2
Dropping Point, °F (°C) Min., ASTM D 2265 500 (260)
Oxidation Stability, 100 hrs, @210°F, ASTM D 942 10 Max
Rust Preventative Properties, ASTM D 1743 Excellent
Water Washout, % loss, @ 175°F, (typical) ASTM D 1264 <5
Salt Spray (Galvanic Corrosion), FTM-4001 Excellent
Boiling Water Immersion, FTM-3463 Excellent, *No disintegration after 10 minutes
High Temperature Performance 500 hours— 10,000 RPM @ 450°F, *Pass
Base Fluid Properties
Base Fluid Type Highly Refined Paraffinic Mineral Oil
Viscosity at 210°F, SUS 76
Viscosity at 100°F, SUS 800
Viscosity Index 95 Min
Pour Point +10°F
Evaporation, 22HRS @ 350°F ASTM D:566 2.9%
Corrosion Prevention, ASTM D 1743 Pass
Timken OK Load, lbs, ASTM D 2509 45 Min
Four Ball Wear, mm Scar Dia., ASTM D 2266 .36mm
Four Ball EP Weld Point, kgf, min, ASTM D 2596 250
Wear, Gear, FTM-335
5 LB Load—1.4 MG wear/1000 Cycle
10 LB Load—1.5 MG wear/1000 Cycle

Magnalube-G