 Test Results |
| In high speed DMS at 250°
F and 350° F Magnalube-G performed better than any other petroleum
oil or grease lubricant. Here's a summary of exhaustive test results similiar
to test data set done in Mil-G-23549 by the Dept. of Defense. |
 |
| Test Description |
Method |
Requirement |
Results |
|
| Dropping Point |
ASTM D-566 |
450° F Min. |
458° F |
| Evaporation, 22 hrs. @ 350° F |
ASTM D-972 |
7.0% |
2.9% |
| Mean Hz Load Weld Point |
FTM-6503 |
50.0° F Min. |
60.5° F |
| Oil Separation, 24hrs @212° F |
FTM-321 |
6.0% Max. |
1.5% |
| Penetration, Cone (Worked) |
ASTM D-217 |
270-315 |
287 |
| Penetration, Cone (Unworked) |
ASTM D-217 |
---- |
284 |
| Penetration, Cone (Work-Stability-100,000 Strokes) |
GTM-313 |
---- |
305 |
| Rust Preventative Properties |
ASTM D-1743 |
---- |
Excellent |
| Water Washout Characteristics |
ASTM D-1264 |
---- |
0.86% |
| Wear Properties (Falex) |
ASTM D-2670 |
---- |
Excellent at 1450 lb. Load |
| Wear, Gear |
FTM-335 |
---- |
5 lb Load-1.4 mg Wear/ 1000 Cycle
10 lb Load-3.2 mg Wear/1000 Cycle |
| Wear, Steel on Steel(4 Ball), |
ASTM D-2266 |
---- |
Wear Scar-0.36 mm (1 Hr. 248° F., 40 Kgs) |
| Salt Spray |
FTM-4001 |
---- |
Excellent (Galvanic Corr., 48 hrs) |
| Boiling Water Immersion |
FTM-3463 |
No disintegration after 10 Minutes |
Excellent |
